Search results

  1. U

    Schrader Valve Leak

    Thanks Joey
  2. U

    Schrader Valve Leak

    The schrader valve on the fuel rail of my 97 disco is leaking through the valve core. I tightened with valve core wrench, but still leaking. I called Atlantic British for a replacement. They do not sell the valves seperate, have to buy fuel rail. Is there a place to order the schrader valve...
  3. U

    CV Joints

    Thanks Maddie
  4. U

    CV Joints

    Thanks for the reply DiscoMike. I was getting my info from the rave manual. It states the following "The wheel bearings are lubricated with grease and the swivel housing and differential with oil." When I pulled the plug to inspect the swivel housing the only thing I could see is grease. So I...
  5. U

    CV Joints

    I have a 97 disco with 197000 miles. I recently purchased the vehicle and have replaced front driveshaft & U joints. I started changing fluids and have changed fluids in both diffs. I checked the CV and all I could see is grease. The rave manual shows that the CV's should have 90w gear oil. The...
  6. U

    Fuel Rail Leak

    Thanks Mike & Joey. I started to take out and put either tape or dope on it, but found the stem was loose. the stem tightened about a quarter turn. I have been watching since yesterday and no leaks. Wade
  7. U

    Fuel Rail Leak

    I have a 97 Disco I that is leaking fuel at the fuel rail. I smelled raw gas when I walked past the disco yesterday. After checking, it was coming from a point that looks like a valve stem. I depressurized the system and used a valve stem wrench to tighten the stem. It seems to have fixed the...
  8. U

    Replacing U Joints

    The brace I was refering to is actually a tie bar to tie the transfer gear box to the transmission. The shop manual shows a pic on section 41 page 3 but is not detailed enough to see where it bolts on to the transfer gear box. Thanks, Wade
  9. U

    Replacing U Joints

    I have a 1997 Disco I with 197,000 miles. This truck was just purchased and everything is pretty much stock except for a 2" lift. I am replacing U joints on the front drive shaft. Actually I am replacing the front drive shaft after a total failure of the rear U joint. I noticed that a couple of...
  10. U

    New Guy

    I just purchased a 1997 Disco with 197,000 miles. I have started working out the bugs. I found this web site while looking for technical advise. I'm doing a lot of reading at this point but will probably have a load of questions later. Thanks, Wade

Latest posts

Members online

Forum statistics

Threads
36,720
Posts
222,745
Members
30,890
Latest member
Besi
Top