F
ftillier
Latest activity Postings About
-
-
Fftillier replied to the thread T44 slider install.Here's pictures of the front, and top down at the front door sill.
-
-
FFit the passenger side shifter installed tonight. A fair gap between it and the body, between 1/4 and 3/8 of an inch. Don't know if...
-
-
Fftillier reacted to Mozambique's post in the thread Multiple dash warnings: Stability control not available / emergency brake assist not available / gearbox fault with
Like.
So........tested the Amazon replacement brake switch I installed a few months back. No continuity in either the brake light or cruise... -
FI'm about to install my t44 rock sliders and the instructions didn't say anything about tightening torque. I looked in the workshop...
-
FSafe to reuse.
-
FDo you replace the springs and adjusters, or are those safe to reuse?
-
FAfter replacing all the bits mentioned above, I still had a leak. Oddly enough, it appeared intermitted. Well, one day at work going out...
-
FChina seems to be viewed like 'made in Japan' was in the '70's. Nothing necessarily wrong with made in China in my opinion. Their EV's...
-
FHeads and block are nice and flat. Unfortunately, since rod bearings 1 and 2 spun, it seems to have given the crank nose a bit of...
-
Fftillier replied to the thread LR4 brakes soft/hard.Is there a strainer under the cap and if so was it hard to remove? Brake flush is on my list, but my rotors are getting old and I'm...
-
Fftillier replied to the thread Disappointed in Wix.I feel like the chance of getting counterfeit junk from Amazon is a lot higher than if you were to order directly from a place like...
-
Fftillier replied to the thread Service manual for '10 LR4 from Original Technical Publications. Any luck searching the files? ( USB drive).==> first link <== worked for me, second one gave me a 404 too.
-
Fftillier replied to the thread Disappointed in Wix.I've been getting the Hengst from FCPEuro. Had to move away from their oil change kits, as they mix up the filters and then the prior...
-
Fftillier replied to the thread E-Pro rebuilder?.@Tapps33 since he's going through this, but I'm not aware of the heads being different.
-
Fftillier replied to the thread E-Pro rebuilder?.Post progress, yes. Rather than swapping in NA pistons, have you considered swapping in a supercharger instead? :D
-
-
Loading…
-
Loading…
