Recent content by ocdiscovery
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Thanks for the feedback and guidance everyone. I really appreciate the help and it looks like we have finally resolved the starting issue. At some point in time, there was a water leak in the cabin. Causing some corrosion to the wiring under the carpeting. After pulling up the carpeting...- ocdiscovery
- Post #46
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Hey, thanks for the info! I definitely would consider the starter. But once it's running, the eco-mode engages and it starts/stops without any issue whatsoever.- ocdiscovery
- Post #44
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Pulled the fuse and relays, everything looks good. Any other advice on how to proceed? Thanks in advance!- ocdiscovery
- Post #39
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Hey Daytona, thanks for the info! Sounds like I wont be checking it next.- ocdiscovery
- Post #38
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Just a quick update: Replaced the brake switch. Still experiencing the same no-start issue.- ocdiscovery
- Post #37
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Thanks for the info! I'll go ahead and order the Gap tool from Lucky8 and follow up later. If anything else comes to mind, let me know!- ocdiscovery
- Post #32
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Thanks for the diagram! I'll follow those wires. Codes have been cleared. All starter relays have been tested. Do you know where I would find the Parking Break Module? I couldn't find it in the cargo compartment.- ocdiscovery
- Post #31
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Both connections look clean and clear of corrosion. I'll access the fusible panel, once it stops raining.- ocdiscovery
- Post #27
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Hey Michael, thanks for the info! Is this box located in the rear of the vehicle? Sorry, don't recognize this module.- ocdiscovery
- Post #25
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Hey, thanks for the detailed info! I believe P065C-01 may have been a pre-existing code. About a year ago the serpentine belt broke, causing the vehicle to stall. I replaced the belt on-the-go, and didn't reset the fault codes. Vehicle ran fine for several months after this repair. I'll go...- ocdiscovery
- Post #23
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Hey, thanks for the info! That's really interesting, as the very first time this issue happened, was the following day after installing our new license plates. My wife mentioned this initially, and I kind of rolled my eyes and shrugged it off. There was some corrosion on the bolts, ultimately I...- ocdiscovery
- Post #20
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Mashed that brake pedal to china. Still has the no-start issue. I will check the transmission fluid, for a sanity check.- ocdiscovery
- Post #16
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Hey fellow Oregonian, thanks for reaching out! I did replace the main battery, even though the original tested out ok. All connections are clean and free from corrosion, or any debris for that matter. Secondary battery looks good, but I'm not 100% sure if the voltage has been tested. Local LR...- ocdiscovery
- Post #15
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Hey DJ, quick follow up. Once you got it running, after pushing the pedal to the firewall, were you able to turn it off and immediately start it without issue, or the additional brake pedal pressure? The only other thing is, after multiple attempts, I can get this LR started, without the...- ocdiscovery
- Post #12
- Forum: LR4
-
LR4 No-Start Issue - Detailed post with Video & Faults - Help!
Hey DJ, quick follow up. Once you got it running, after pushing the pedal to the firewall, were you able to turn it off and immediately start it without issue, or the additional brake pedal pressure? Thanks again for the follow up.- ocdiscovery
- Post #10
- Forum: LR4
