Search results
-
damaged diaphragm in right-side airbox
It's very common for those to disintegrate. You can find some silicone sheets and cut a new diaphragm.- Rover Range
- Post #2
- Forum: LR4
-
2012 Range Rover Sport HSE LUX - Passenger seat Cushion Replacement
You may be better off taking the seat to an upholstery shop. The seat bottom cover is held on with "hog rings". They require special pliers to install. There are 15 hog rings. Getting the cover on nice and tight requires a steam machine too.- Rover Range
- Post #2
- Forum: Range Rover
-
8-Speed Transmission Pan
Good tips. Couple things. Exhaust doesn't have to be removed. Just remove the right motor mount and jack up that side of the engine. Never use RTV in a transmission.- Rover Range
- Post #2
- Forum: LR4
-
2013 auto high beam assist
You're welcome. 7 SEAT CONFIGURATION 19 ALLOY 7-SPK 255/55 R19 A/S TYRE 7143 LBS USA/MEXICO AMBIENT LIGHTING AMERICAN MOBILE PHONE SYSTEM ATC AIR CONDITIONING AUTO HEADLAMPS-FOLLOW ME HOME AUTOMATIC GEARSHIFT AUTOMATIC HEADLAMP LEVELLING BADGE-HSE (TRIM LEVEL) BADGE-LR 4 SALES BRANDED SURROUND...- Rover Range
- Post #9
- Forum: LR4
-
2013 auto high beam assist
Post your VIN #. I'll pull up the vehicle's build sheet.- Rover Range
- Post #7
- Forum: LR4
-
LR Defender for 2025 is dropping the 18" rim
Sales may have been the deciding factor. Remember when 15" rims were the standard? :oops:- Rover Range
- Post #2
- Forum: Defender L663 (2020 - Present)
-
U3000-63 & "Park Aid Unavailable"
DTC U3000-63 is set when there is a continued park aid sensor failure. I'm not sure if your scan tool is pulling up all the DTCs. Park aid module is located in the left side of the cargo area. Right behind the 2nd row seat. C0958 points to it.- Rover Range
- Post #8
- Forum: LR4
-
U3000-63 & "Park Aid Unavailable"
You may have to press your ear directly on the sensors. Or use a piece of 1/2" hose.- Rover Range
- Post #6
- Forum: LR4
-
-
U3000-63 & "Park Aid Unavailable"
Park aid sensors emit a faint clicking sound. Like a bat's sonar. Go around the listen to the sensors. The one that doesn't click is defective. A bad sensor can pull the system down.- Rover Range
- Post #2
- Forum: LR4
-
Valve Lifter Tapping
By "cleaning" , they are probably doing a BG oil system service.- Rover Range
- Post #2
- Forum: Discovery
-
Low tire pressure indicator light didn't shut off
A lot of new Rovers don't even have a spare tire or jack. They are looking at weight savings vs convenience. Plus, it's a liability for someone to change their own tire. :oops:- Rover Range
- Post #34
- Forum: LR4
-
My new LR4 Journey
Send me your VIN#. I can pull up the build sheet for it.- Rover Range
- Post #5
- Forum: LR4
-
Rear Brakes on 2014 LR2
Correct. Use an allen wrench to turn the actuator.- Rover Range
- Post #3
- Forum: LR2
-
I think mold got on my seats
Spray with LYSOL and wipe the seats off. Change the cabin filter too. While the filter is out, turn the AC blower on high and spray LYSOL into the blower motor. That will **** the mold in the AC ducts. The heat from the invertor kept the moisture at bay.- Rover Range
- Post #3
- Forum: LR4
-
Tech inspection failed
The retaining ring probably got dislodged during shipping. When the boot dropped down, it got caught against the ball joint. Tearing it. Should be a parts warranty repair.- Rover Range
- Post #3
- Forum: LR4
-
Greasy transmission, should I be worried?
I've only seen two rear main seals that were bad. Both vehicles had this weird groaning noise. There was actually a vacuum leak through the rear main seal into the torque convertor cavity. I could feel engine vacuum at the transmission bell housing weep hole.- Rover Range
- Post #31
- Forum: LR4
-
-
Greasy transmission, should I be worried?
It pays 10 hrs to R+R the transmission. So, quote is about right. Also, you have to factor in things that can go wrong. Like broken cat convertor bolts.- Rover Range
- Post #26
- Forum: LR4
-
5.0 metal rear coolant manifold
Two screwed together halves? No thanks.- Rover Range
- Post #2
- Forum: LR4
-
Cable hanging down (damaged) from my rear passenger wheel well (Update: Resolved!)
Usually, the sensors become brittle from all the heat etc. It's best to go ahead and change the sensor.- Rover Range
- Post #12
- Forum: LR4
-
Help identifying sound coming from engine bay
With the engine running, pour water on the belt. See if noise goes away. If it does, belt issues.- Rover Range
- Post #5
- Forum: LR4
-
engine noise
Sounds like the engine cooling fan. There is a software update to correct this issue.- Rover Range
- Post #2
- Forum: Defender L663 (2020 - Present)
-
Cable hanging down (damaged) from my rear passenger wheel well (Update: Resolved!)
The brake pad sensor was not replaced. The sensor has an internal wire that wears through, indicating the pads are worn.- Rover Range
- Post #6
- Forum: LR4
-
Oil filter cap
The bypass valve can be snapped back into place. Align the tabs properly. Then use a socket and an extension to push back in place.- Rover Range
- Post #4
- Forum: LR4
