Search results
-
L
MAF where to buy...
Hi all I am getting codes P0171 and P0174 and I believe its time to replace my mass air flow sensor MAF (2000 D2 with 85,000 miles). I have seen the discussions about NOT buying aftermarket MAF sensors, cleaning or not to clean, etc., and I am really NOT trying to open of a can of worms... -
L
'00 Disco2 intermittent start problem
Hi John Sorry to hear you are having similar problems. I wasn't getting any codes either, the engine would just turn over and over and never start, then on the 2nd, 6th, or 10th try (no pattern) it would just start right up, and run fine. There were a couple of times I couldn't get it... -
L
02 Sensor Issue, P0130
Update, problem solved. Problem solved! Details below... As stated in my previous post, after initially replacing the Bank 1 Sensor 1 (left hand drivers side front) O2 sensor, I kept getting the following codes: P0134 Bank 1 Sensor 1 P0135 Sensor Heater Circuit Malfunction Bank 1 Sensor 1... -
L
02 Sensor Issue, P0130
replaced O2, now P0134 P0135 P0155 Hi all I replaced the Bank 1 Sensor 1 (left driver front) O2 Sensor, cleared codes and everything was good for about 10 minutes. Then another Service Engine Soon light... Now I am getting the following codes: P0134 Bank 1 Sensor 1 P0135 Sensor Heater... -
L
02 Sensor Issue, P0130
Hi All I know there have been other threads on Oxygen Sensor replacement, but I replaced one about 6 months ago and now the codes say its bad again???? Details below: I have a 2000 Discovery II with 85,000 miles on in. About 6 months ago, the Service Engine Soon (SES) light came on, and I... -
L
'00 Disco2 intermittent start problem
Crank Shaft Position Sensor installed - STARTS GOOD I installed the new crankshaft position sensor, and I believe my problem is solved. I'm certainly no mechanic or expert, but below is some info on my experience. Also, here is a link to a short you tube video I found on replacing the... -
L
Crank Shaft Position Sensor installed - STARTS GOOD
I installed the new crankshaft position sensor, and I believe my problem is solved. I'm certainly no mechanic or expert, but below is some info on my experience. Also, here is a link to a short you tube video I found on replacing the crankshaft position sensor (CPS) on a Discovery 2... -
L
'00 Disco2 intermittent start problem
Mike, thanks. I tried your suggestion and it started. Just to make sure I followed your instructions: with the engine cold, I turned the key to 2nd position and and waited 5 seconds, then turned it off, then repeated this process. On the fourth time, I tried starting and it started... (I... -
L
'00 Disco2 intermittent start problem
Greg, thanks for the advice. I am waiting on the replacement sensor (ordered yesterday), but I crawled under this afternoon and I can see the crankshaft sensor cover, and I think I can barely reach it once I get the truck up on some ramps (won't be easy), but I'm worried about being able to... -
L
'00 Disco2 intermittent start problem
Thanks for the advice. I have ordered the crank position sensor from Atlantic British, and will report back once I replace the old one. Hopefully it won't be to hard to locate and replace. Any advice on where it is or tips on replacing would be appreciated. Thanks! Lee 2000 Discovery -
L
'00 Disco2 intermittent start problem
Sounds like the consensus is crankshaft sensor... Should I have received any ODB codes on this? I wish there was a way to test or diagnose (other tham simply replacing). Lee -
L
'00 Disco2 intermittent start problem
Hi all I have a 2000 Discovery II with 80,000 miles on it. I have had it for about a year, and it has been running fine. However, it is having a starting problem. It will crank fine and turn over good (strong battery), but acts like it is not getting gas or spark. Then, all of the...
