greiswig's latest activity
-
greiswig replied to the thread Fan and lean codes.Do you have to? The plate should still be partly open at idle, no? -
greiswig replied to the thread Smoke test, P0170 code and PCV.I hope, but I doubt it; the fuel trim code has been happening on long trips long before the misfire started. Nobody knows whether it’s...
-
greiswig replied to the thread Coolant in transmission cooler?.Possible if the heat exchanger split or developed a leak. Do you have any kind of feel for how long you’ve been driving it in that...
-
greiswig replied to the thread Routing for stout wires from battery to back?.I appreciate it! That's what I was looking for. It's a similar-sized wire.
-
greiswig reacted to djkaosone's post in the thread Routing for stout wires from battery to back? with
Like.
There's a little rubber grommet underneath the brake booster, it's near the 11:39 minute mark of the video. That's THE best way to do... -
greiswig reacted to drivesafe's post in the thread Routing for stout wires from battery to back? with Like.
Hi greiswig, from your post I am guessing you want to run the cabling down the chassis and up into the cargo area. If this is the case...
-
They don't have a satisfying pop when they are seated. There is a crazy long spring in the tube that grabs the head of the spark plug...
-
greiswig replied to the thread Routing for stout wires from battery to back?.I have the solution, just not a good routing for the wires.
-
greiswig replied to the thread Persistent misfire under load only.One other thing on this before I put it to bed. That test I did where I pulled the coil off the plug to see what cylinder was actually...
-
I'm trying to install some wiring to get more current back to the rear cargo area, to be able to more quickly charge an Ecoflow battery...
-
greiswig replied to the thread Smoke test, P0170 code and PCV.OK, thank you. Do you have any suggestions for what I should look at to gauge whither cometh this "P0170-00 (27) Fuel trim (bank 1)"...
-
I’m not 100% on this, but I think fuel trims are not very valuable readings during acceleration/deceleration, only cruising and idle. I...
-
greiswig reacted to timc930's post in the thread Where is this supposed to be bolted? (Part #EH22-13N850-FC) with Like.
Yes, What ever they pay him, it’s not enough!
-
greiswig replied to the thread Smoke test, P0170 code and PCV.Man, I wish the export feature on the GAP tool worked better. I recorded a fairly lengthy run with a few hard accelerations, monitoring...
-
-
TL;DR - should the PCV valve be sealed tight enough that a smoke test won’t leak through it? Long version: Now that I think I found...
-
