It's when the truck isnt moving, like when you turn the wheel getting ready to make a sharp turn....sad to see CV's on the list....
I did have the truck in the sand not too long ago as well....it did so good! I just hope that I dont have to pay for it now....
Hello everyone,
I recently noticed that when I steer all the way to the left there is a clicking noise coming from driverside wheel. Is there something that I could check myself?
Mike,
If im understanding what youre saying all I have to do to bleed the brakes is use a syringe to take the old fluid out of the resevior, fill it with new fluid and then start at the rear of the truck and let it drip untill the clear fluid comes through-making sure to keep it topped off? No...
Mine just started doing this as well, could it be due to the brakes really needing replacement? The lights come on everytime if I have my foot on the brakes and then tap the gas at the same time...
Mike,
Thanks for the reply! Should I get the Ebc kit or stick with OEM stuff, don't you run the EBC's? What will an impact wrench with the right bit set me back? Where can I find a PDF service manual on this truck?
Thanks!
Sorry,
Its a 99 D2 w/68k on it. I have done brake pads on hondas and complete jobs on 60's VW's. Any advice is greatly appreciated, also are there any odd tools that I might need to have--like over sized sockets etc.?
Hey everyone,
I have to do my brakes by the end of this month. I am looking at doing a complete job all the way around, rotors + pads. I am looking for some advice....I think I have about three options.
1. Go to the dealer and pay upwards of 800 for an OEM set of brakes.
2. Get the...
One of the seats in the second row of my truck wont fold up all the way. It feels like the linkage to release it from the floor isnt engaging? How the hell can I fix this if I can access the mechanism with the seat stuck halfway upright?
Hello again,
I need to have my brakes done soon and I was wondering if anyone had ever had this done in Portland OR before. Im thinking of going with an aftermarket pad/rotor setup and I also wanted to know what you guys use for brakes. Is this a job I could do myself if I have done brakes...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.