-
-
mm3846 replied to the thread Longevity and Investment.20mm spacers or new wheels with an additional 20mm of offset changes the effective offset (and therefore scrub radius) the exact same... -
mm3846 replied to the thread No fluid coming out when bleeding rear brakes.You probably need to bleed the ABS pump. You need a diagnostic tool for that.
-
mm3846 reacted to Pfunk951's post in the thread Write up: High Pressure Fuel Pump (HPFP) Replacement with
Like.
Pump removal I’m not going to lie- it’s going to get tight here. We’ve got a frame rail right in the way, but plenty of room in front... -
mm3846 replied to the thread Thoughts on switching from 5w20 to 5w40 as miles approach 200K?.It’s totally fine. And it’s a better (the additive pack) and thicker oil with better timing chain protection. I’m running Castrol euro...
-
Yep. I've owned a D2 (new), L322's (new), and LR4 (very used). The LR4 is the vehicle that has completely ruined me. Literally...
-
mm3846 replied to the thread Thoughts on switching from 5w20 to 5w40 as miles approach 200K?.I’m running 0w40 and have been for the last two changes. Just about 100k.
-
mm3846 replied to the thread 2015 LR4 front end sagging overnight.Looks like I’m all set after the calibration.
-
mm3846 replied to the thread 2015 LR4 front end sagging overnight.Shame on me, I pulled the compressor fuse but not the sensor fuse. Left it all day, no sag. I’ll run another calibration tomorrow.
-
mm3846 replied to the thread 2015 LR4 front end sagging overnight.Alright. Tightened the fittings, started losing air from all four corners. Replaced the front valve block with a new one, new VOSS...
-
mm3846 replied to the thread 2015 LR4 front end sagging overnight.Alright, calibrated. It was pretty close, or my measuring was off. Either way, we’ll see. Front end lifted on startup and the truck was...
-
mm3846 reacted to ftillier's post in the thread 2016 LR4 Original Owner. 75k. Thinking about selling, but not sure of alternative rides that can do everything this does. with Like.
I would venture keeping your LR4 in tip-top shape is likely far cheaper than buying a new 4x4. Refresh the cooling system, check the...
-
mm3846 replied to the thread 2015 LR4 front end sagging overnight.Interesting. I tightened up the fittings at the block and now the rear sags a bit too. I’ll do a calibration tonight. I ordered a new...
-
mm3846 replied to the thread Prospeed product interest?.I ended up giving up on this as there wasn’t enough to make it worthwhile. Prospeed will ship to US if you ask. I ended up with an air...
-
Why not just go the ARB route? No question on whether works and you’ve got control over it rather than relying on the traction control...
-
I'd leak test the VOSS fittings first and try tightening them if they leak...
-
-
Loading…
-
Loading…
