That sounds like quite a job. When I pulled my heads to change the gasket, one of the first things I did was check the sleeves. Luckily, all were ok.
I'm still disappointed that I've had these issues with less than 60k. But, I love this truck (when it is running well)!
Just want to follow up on this. I used KW block sealer this past weekend with great results. No more misfires, no CEL and the engine is running much smoother at start up. I can't believe this stuff works. We'll see how long it lasts....but for $8 and 20min job I'm really happy with the...
I had this happen on my '04 disco. No CELs but it was these readiness codes. Turns out if you have disconnected your battery or re-set any CELs, you will need to drive about 75-100 miles or so to turn them off. For me, I had all 5 readiness codes flash when I tried to get an inspection (I had...
So, just to follow up on this. I ended up replacing both head gaskets. What a PITA job....about a 20hr job in total. Anyway, what was interesting was that the old gaskets looked ok to me...no noticeable tears or holes that would allow blow-by. The heads / valves were also in decent shape...
Thanks for the quick response. Yeah, I forgot to mention that seafoam was the first thing I tried....with no change. Ran a few bottles through the gas too. Think I should just bite the bullet and pull the heads? I'd hate to do the job and still have the same issues...
I performed a compression test, and the numbers don't really indicate a gasket leak....or do they?
Test was performed after truck was fully warmed up, all plugs removed, fully charged battery with throttle wide open.
#2:155
#4:143
#6:144
#8:136
#1:151
#3:150
#5:146
#7:142
What concerns me is...
Funny....I had ordered another set of STI wires just to check this. Unfortunately, after changing the wire I'm still getting the #6 misfire. I just ordered my gasket set and head bolts today to do the job after xmas. I'm a little disappointed that I'm having these issues at <60k miles, but...
Hi, just curious as to how long it took you to complete the head gasket job? Did you require any special tools, besides the shop manual or torque wrench? Thanks.
Just pulled the plugs tonight....they all looked the same to me, then again, they were replaced about 3k miles ago when I did the wires.
Yeah, I wouldn't be surprised if they wanted to sell me a new engine. I was hoping to get at least 100-130k miles out of this engine until I needed a new...
Hi everyone,
I've had a P0306 (#6 cyl engine misfire) intermittently now for about 5,000 miles. The check engine light (with this code) usually comes on when I start the rover and drive it before letting it warm up - but this only occurs maybe only 2-3 times/month and the CE light it will...
I tow 6500lbs, no issues....
Hi,
I tow my 27' boat with my '04 Disco with no issues. Boat weighs about 5500lbs and the trailer is about 1200lbs. 6700lbs in total, and I've totaled at least 300 miles if you sum my trips. I use the low range when I'm off the highway and keep the speeds...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.