Search results
-
2016 LR4 Landmark SCV6 Engine Failure at 65k. WWYD?
A repower with this engine would be very cool. https://www.cummins.com/engines/repower- Rover Range
- Post #42
- Forum: LR4
-
LR4 Trailer Hitch Service / Rebuild
The trailer wirin connector plugs are located behind the left tail lamp.- Rover Range
- Post #27
- Forum: LR4
-
Thermostat to water pump outlet connector
You have to remove the old plastic sleeve and o-ring. Insert the new o-ring in the water pump. Make sure it is seated properly. Install the plastic sleeve. The brass piece is then inserted all the way in.- Rover Range
- Post #12
- Forum: LR4
-
Second battery died after 1 year - battery or something else?
Walmart. Nuff said.- Rover Range
- Post #2
- Forum: Range Rover
-
-
Transmission Breather Tube Location
Should be two metal tubes attached to the rear of the rear coolant crossover pipes.- Rover Range
- Post #2
- Forum: LR4
-
Channel covers off - cleanup complete.
There are plastic push pins that hold the finisher on. You can use a bolt with a stud in place of the push pin. Then attach your antenna to the stud with a wing nut.- Rover Range
- Post #5
- Forum: LR4
-
LR4 Air Suspension Fault - Inflating too fast?
If your old compressor was a Hitachi. The chassis control module will have to be reconfigured for the new compressor.- Rover Range
- Post #8
- Forum: LR4
-
Harsh ride, suspension issues ?.
Check tire pressures first.- Rover Range
- Post #2
- Forum: Introduction
-
Roof Rail installation
https://accessories-instructions.landrover.com/enUSA https://accessories-instructions.landrover.com/enUSA/discovery- Rover Range
- Post #3
- Forum: LR4
-
Roof Rail installation
Part of the existing rail covers will have to be reused. The bolt holes do go all the way through. Unused bolt holes will have plastic plugs in them. These will have to be removed to allow the roof rails to be bolted on.- Rover Range
- Post #2
- Forum: LR4
-
Crazy to consider new engine in a 2016 LR4?
Believe it or not. This stuff works. Not permanent of course...- Rover Range
- Post #28
- Forum: LR4
-
Windscreen Vendors ?
There's no more safety inspections anymore. Just emissions. Cracked windshield won't fail the inspection.- Rover Range
- Post #3
- Forum: LR4
-
-
Crazy to consider new engine in a 2016 LR4?
That was the cost for a reman engine from Land Rover.- Rover Range
- Post #23
- Forum: LR4
-
-
LR4 Trailer Hitch Service / Rebuild
Cut away the plastic with a hack saw.- Rover Range
- Post #7
- Forum: LR4
-
Crazy to consider new engine in a 2016 LR4?
Last one we did was $10K, just for the engine. You'll need all the gaskets etc.- Rover Range
- Post #14
- Forum: LR4
-
LR4 Trailer Hitch Service / Rebuild
On the green part, there's a roll pin you have to push out. Then the green part slides off.- Rover Range
- Post #4
- Forum: LR4
-
Coolant Temps
^ Correct. On the V6: The thermostat begins to open at 208-215 °F and is fully open at 226 °F. The V8: The thermostat begins to open at 190 - 194 °F and is fully open at 216 °F.- Rover Range
- Post #9
- Forum: LR4
-
Crazy to consider new engine in a 2016 LR4?
Check with your local dealership. There's a massive price reduction on JLR reman engines.- Rover Range
- Post #6
- Forum: LR4
-
Electric Oil Pump Control Solenoid on a 2016 3.0l?
No oil pressure sensor. Oil pressure is not monitored. :dontknow: To test the oil pressure, you will need a tool like this. Or, find another oil filter cap and drill a hole in the top to screw in a guage. https://www.freedomracing.com/2021500090-late-version-3-6l-oil-pressure-test-adapter-tool.html- Rover Range
- Post #11
- Forum: LR4
-
Troubleshooting coolant vacuum fill failure
A coolant temp sensor doesn't measure air. Unfortunately, lots of overheated engines because of this. Coolant in the oil pan could be a cracked cylinder head.- Rover Range
- Post #53
- Forum: LR4
-
Diagnostic Trouble Code: B1A85-96 (28)
It can. With the wipers in auto. You should be able to spray some water on the windshield and active the wipers. Also, the high beam assist sensor could be blocked by a toll tag sticker. The aftermarket windshield could be diffusing the light away from the sensor in the front of the mirror.- Rover Range
- Post #7
- Forum: LR4
-
Diagnostic Trouble Code: B1A85-96 (28)
If you have an aftermarket windshield, it can cause all the issues you've described. #2 sensor controls the high beam assist.- Rover Range
- Post #4
- Forum: LR4
