I found 2 burned bulbs in the taillights, and 1 small burned bulbs in the headlight. All 3 have been replaced, brake switch replaced and no luck. I read some codes again and got "front left wheel speed sensor circuit" which I also replaced both of them new about a week ago. Do they have to...
The brake wear sensor is Alex plugged in I found things one coming down the center of the truck before the spare tire..
Sent from my SM-G955U using Tapatalk
Special programs not available, cruise control not available, and when I hit the button to try and raise it both arrows flash,
Sent from my SM-G955U using Tapatalk
I really appreciate your reply, at this point the compressor is only turning on once in a while when I start the vehicle. It wont raise at all dash shows cruise control off and a few more messages. And both roll over lights turn on. Last time I read the battery it showed 14.7
Sent from my...
I recently have the suspension fault, the 2 roll over lights, and brake lights on. The truck wont raise at all, and during inspection i found a loose connector in the rear center of the truck right before the spare tire. But it's not the one that connects into the brake sensor but similar. Can...
I tried the hard reset and everything appears to be the same. The only thing I saw that was reset is the time in the radio.
I also looked for more air bag sensor or the yellow and green wire and found the below pic to the left of the battery. At first I taught something got loose but I cant...
I will try the hard reset next, but I was told it wouldn't pass emissions because of the air bag being on and it's a safety issue.
Thank you,
Sent from my SM-G955U using Tapatalk
Can someone please guide me in the right direction. I have cleaned both air bag sensors on the front seats and can't clear the light. How many more sensors does the LR3 have? Where are they located? I need to pass emmisons in the next couple of days.. any help is greatly appreciated..thank you...
Yes it's a v8 and it seems that the problem was the mass air flow sensor. I replaced it a week a go and it was running good till today. For some odd reason the heck engine light started flashing and engine running rough. Today I dropped it off at the shop..
Sent from my SM-G955U using Tapatalk
Can someone please be so can and tell me where it's at in the LR3? I ordered it by mistake and would like to go ahead and change it out
Thank you
Sent from my SM-G955U using Tapatalk
So I finally got around to changing the spark plugs, coils and the problem continues. I clean the mass air flow sensor and the truck is running great again.
Sent from my SM-G955U using Tapatalk
I have the same issue with my LR3, My solution was to place a cigarette butt on the base of the hood latch and it works. I will try a to load a picture if you need it. GOOD LUCK
Sent from my SM-G955U using Tapatalk
I recently bought some from Amazon and they worked great for about 2 months. Now I'm back to square one with a bunch of misfiring in the engine. According to the scanner it point out the ignition coil #7 #5 are the problem. I've moved both around only to generate more engine codes. What brand...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.