M and S lights are on

[Furmando]

code P07005 is reading a friend said its most likely the Neutral safety Switch... dont want to waste the money so fast. Any suggestions on how to fix the M and S ?? thanks

 

[Disco Mike]

I don't believe that is a good number. If your M&S are flashing first check and make sure your battery cables are clean and tight as well as the ground cable, then go get your voltage check at a local parts store. Should be between 13.6 and 14.4 volts.
Are you currently driving in limp mode?

 

[Furmando]

Voltage

The batterry is running at about A 12 and i just replaced the Alternator and im trying to figure out what mode its running in? I dont see a mode light to indicate what mode its in (mode button bellow the shift) but i do know that Its running on H and im trying to figure out how to put it back to N.

Thanks

 

[Disco Mike]

If the truck is not starting up in 3rd gear you are OK.
Get the voltage checked cause 12 volts won't cut it, the computer need a minimum of 13.6 volts.

 

[Furmando]

it was a little more then 12

it was around 13 or so the guy said it was perfect .. what mode should it be in?? how do i know if its in limp??

 

[Disco Mike]

Already answered that question, if you are in limp mode you usually start up in 3rd and have no power. Do you have an owners manual, may want to read it.