Recent content by MikeLi
-
LR3 Rear Brake Rotors and Pads FS
you want to sell just the rotors? Unless you have a set of ebc pads? -
Magnaflow exhaust
I've installed one get new exhaust hangers it's easier to cut the hangers then try to pop the old exhaust off. Get a torch to heat and expand the pipes so they will slip on easy. Get some exhaust paste. Get a piece of 1/2 hose and zip ties you might need then for the back hanger rods... -
Help! Warning lights and Rover going crazy
I have exactly the same problems as you with all the same messages popping up but I have one weird then that happens on and off. The transmission in auto will not upshift. I have to put it in manual mode to up shift each time. Maybe I'll try and see if I can pick up a break switch tomorrow if... -
radio/nav fail
My whole nav system doesn't even start up at all and the radio sections dimmer lights are off also. The only way I can get the naz system to reboot is to pull the fuse. Then it might work for several on and offs but usually after I shut off it won't boot up again. Going to take to dealer soon... -
Purge Valve Code fault P0441
Got a OEM part from the dealer. The engine light goes away and comes back with the same code. I try clearing it and it just comes and goes still. -
Purge Valve Code fault P0441
Ok guys I can't figure out what keeps causing this light to pop up P0441. I already replaced the purge valve and it didn't help. I even checked the gas cap to make sure the seal is still good and no problems. Checked for vac leaks and can't see any leaks. Does anyboyd have any idea what's... -
Check Out My new Grill
I like the way it ties the headlights together. I wasn't able to pull the badge off so I have to order one. Going to get the black and sliver badge. -
Check Out My new Grill
Got this off E-bay. Fits pretty nice and looks pretty good too. Check the pic below -
-
hankook tires
I have a set on my LR3 HSE. They very quite and seems to wear slow. Pretty good in the rain too. Could be a bit better in the snow but it's still pretty good. -
Brake noise after replacing rotors and pads
I have the same problem just did the front rotors and EBC pads all around. They are making noise too. I'll just let it go longer to see if it goes away. Usually it's just the brake dust causing the noise. If it doesn't go away I'll just take the wheels off and clean up the brake area with... -
Service Manual (aka Shop Manual)????
Does anybody have any idea on where I can get a service/shop manual for the LR3? -
LR3 Fuel Door Does it Lock???
I just noticed that I can open my fuel door on my LR3 when the truck is locked. Does anybody know if it's suppose to lock or not? :confused: -
New Custom Intake Tube
I put in a breather for the valve cover. Put they do sell a tube connection kit for it. You'll have to drill a hole and install a ****** so the hose can go in the same place. -
