Recent content by deeb
-
D
Couple D1 issues (igntion, keys, etc)
hey all, the vehicle in question is a 97 discovery with around 130k i recently had a key broken off in the ignition. i was able to retrieve the key fragment..however i broke the plastic switch which is located at the end of ignition (the piece that connects the fusebox under steering wheel to... -
D
Blower Motor
its winter in maine and we have no heat! ive tried fiddling with the switch and no luck. so theres a fuse, relay, resistor, and fans switch all before the blower motor right? fuse is good. wheres the relay? its a 98 i have the resistor out. can those be tested before i go buy a new one... -
D
Fuel Pump
i just dealt with a similar problem. easiest thing to do is pull up your carpet in the hatch and take the cover off. you can look right at the fuel pump, if you see 2 electronic connectors its the newer evap setup. but like mike said, its a 96 so it should be older fuel pump system. good... -
D
Front Blower Motor won't run
is this a disco 1 were talking about here, because im having a similar problem with a 98. sorry, not trying to hi jack the thread... ive checked my fuses (under hood and under steering wheel) where is this relay you guys speak of? also, i found the resistor. (behind the passenger side kick... -
D
Disco 1 Radiator
looking for a decent radiator for a 4.0 auto. shipped to southern maine? 04038 thanks -
D
cooling system / overheat help
my 97 disco with 108k is overheating. the cooling system is full and an air lift was used to get all the air out the head gaskets have been replaced the thermostat has been replaced the fan clutch is working the water pump is good all fans are operating as they should the truck has... -
D
radiator plug
can anyone tell me the specific size of the fill plug on top of the radiator of a a 97 disco I. the replacement part is cheap online, but i dont want to buy that cheap plastic one again....id rather go to lowes. thanks chad -
D
need a christmas miracle...
so does switching to these flanged liners require engine block counter boring to accept the new liner style? also, will it require a new head gasket set? thanks for your help chad -
D
need a christmas miracle...
So the cooling system is being pressurized in my 97 disco w 108 k . My mechanic buddy just finished doing the headgasdkets and its still showin the vsame symptoms! the job was done right, both heads were magfnafluxed and machined. Any ideas other than a crack in the block? Please. Thanks... -
D
Head Gasket Fix and Bad Gas Mileage
excuse my nosy-ness, but how much did you pay for the head gasket job? was it done on both sides or just one? im on the brink of the same thing and curious what im in for. thanks chad -
D
head gasket
So my cooling system is being pressurized and I'm leaning towards a bad head gasket. Is there any good way to discriminate between the left and right heads? Thanks Chad -
D
oil cooler lines on a 96 discovery
hopefully im not too late with this... i just dealt with the same thing with my transmission fluid cooler. i brought it to a hydraulic shop and they said it would be way more expensive to fabricate one. theres a company called autoparts international that makes their own parts to replace... -
D
Disco 1 Brush Guard
anyone have one theyre looking to get rid of....? thanks chad -
D
oil leak from oil pressure switch
thats what i would do. rubber o-ring.
