Search results

  1. Mach1s

    Suspension Fault

    Follow the link above from hell pie. I think someone on that thread had the dealer fix theirs for a cost of about $1400,00 as I recall. he pump is very easy to replace with very few tools needed. There is a thread that someone started showing it step by step. A new air pump from LR is like...
  2. Mach1s

    Suspension Fault

    I would start the truck and try to raise it to Off Road Height right away before the light has a chance to come on. If it raises, let it sit in the raised position over night and see if the height changes. Upon restarting the truck, see if the light comes on. I could raise mine and it would stay...
  3. Mach1s

    Need LR3 Passager (right) side rear door.

    Need a door to replace a banged up one on my 06 LR3. It would be nice to get one in White to match mine but will consider others. Let me know what you have and a price. Thanks!!
  4. Mach1s

    Suspension Fault

    You can compare it to Hell Pies thread. He has better pictures of the LR pump
  5. Mach1s

    Suspension Fault

    The Ford motor is smaller than the LR motor and the circuit boards are very different. The Ford does not use a rear bearing to support the rear of the rotor like LR does either. they seem to be completely different animals. Here is a pic of the Ford motor.
  6. Mach1s

    Suspension Fault

    Here is a pic of my burn't out motor. Pic is blurry but you get the idea. Camera cannot seem to focus at close range.
  7. Mach1s

    Suspension Fault

    Vacuum side
  8. Mach1s

    Suspension Fault

    Back on Topic Got the Ford compressor and it is different. It may work but you will still throw codes is it has no provisions for the thermal sensor and the exaust is not compatable. Look at the pics. I broke down the Ford unit to see what went wrong with it and it seems to have a severe...
  9. Mach1s

    Name that steering sound

    I would check the upper control arm to make sure it is not rubbing on the aluminum air bag can. You may have some damage from wheeling that you don't know about.
  10. Mach1s

    Suspension Fault

    I am picking up a used Expedition compressor tomorrow from my friend @ Ford. I will post pics of the pump. Took my OEM pump apart today... Everything is good but the small circuit board @ the base of the motor. If anyone has an old pump laying around, I will pay shipping??? I will post pics of...
  11. Mach1s

    Suspension Fault

    I wondered the same about the Mr. Glasscock post. This is what they sent me. Marion said he will try to come up with something else. It is a pdf. file. Can't upload it. Dam, not really any good info anyway. Will try to change file type.
  12. Mach1s

    Suspension Fault

    Talked to Marion @ arnott and he said they have nothing yet for the LR3. Said they are working on the bags first. He thinks the Ford pump will work but no thermal switch and different mounting locations. He is going to send me a spec. sheet on it so I can compare it to the LR3 pump. Here is a...
  13. Mach1s

    Suspension Fault

    Expedition Pump Here's a picture. Hopefully this works. The lines are different and the wiring.
  14. Mach1s

    Suspension Fault

    The Expedition pump is definetly different but only like $180.00. Here is a link http://www.amazon.com/1998-EXPEDITION-SUSPENSION-COMPRESSOR-DRYER/dp/B004DZ2EU2 If anyone has done this, PLEASE let me know!!
  15. Mach1s

    Suspension Fault

    Anyone have any idea what year Expedition (Ford) Compressor works on the LR3? Does anyone have a diagram as far as what the ports on the pump are and maybe a diagram of the EAS system? Would like to setup an schrader valve to pump up the air springs in case of failure like this. It's hard to...
  16. Mach1s

    Suspension Fault

    Tested the compressor as shown and nothing. Smells bad as well. Looking for a replacement. Anyone purchased anything from Rovers Land (Ebay) Says rebuilt compressor w/1 year warranty for $405.45 shipped. Good Deal or not??
  17. Mach1s

    Suspension Fault

    Checked all the fuses and relays. I will try to jump the Compressor as shown in the pic (thank you) . I seen the air tank under the drivers door but did not notice the compressor. I will look closer for it and visually inspect it.
  18. Mach1s

    Suspension Fault

    Battery tested out to 802 Cold Cranking Amps, Voltage is 12.54V out of truck.
  19. Mach1s

    Suspension Fault

    OK truck is down to bump stops and Dealer can't get me in until the Feb. 21st!! Checked the wire connections on the height sensors, they are OK, the battery is going in today to get tested. Where is the compressor located? can I test it somehow? Can I test out the height sensors? Where can I get...
  20. Mach1s

    Quick snowplow option for LR3?

    Is that thing for real?? Seriously!
  21. Mach1s

    Suspension Fault

    Ok, Ford Dealer came up with Immobilizer key mismatch. Code # P0513. They had no idea what that meant. Called LR Dealer (70 mi away) said that is a security code not a suspension code. Can I get the suspension codes read anywhere but the dealer? Can I clear the codes and see what happens? I did...
  22. Mach1s

    Suspension Fault

    See below
  23. Mach1s

    Suspension Fault

    I will ask my Tech friend at the Ford dealer to pull the codes for me. I would assume a Ford reader will work seeing they owned them at the time. A rear break light bulb? Really? Thanks for the reply.
  24. Mach1s

    Snow mode

    Snow Mode is fine with limited slippery conditions. The CPU constantly monitors the wheels and applies brake to wheels that slip so wheels that have traction can continue as well as many other functions. You may get a little worse MPG in any of the Special Traction Modes.
  25. Mach1s

    Suspension Fault

    Ok, I scanned the forum and not found my answer. 06 LR3 HSE with 45,000 mi. out of warranty. The other day my wife takes daughter to doctor. 15 miles to doctor, on the way home, suspension fault light turn amber says "normal only" 5 miles later RED light. She gets home parks in garage says...

Latest posts

Members online

Forum statistics

Threads
36,272
Posts
218,137
Members
30,499
Latest member
Vintage99
Top