Disco Mike
Full Access Member
- Joined
- Jun 20, 2009
- Posts
- 1,949
- Reaction score
- 5
Remove the idle control unit and clean all the carbon from it as well as in the hole it mounts into.
cleaning o2 sensors
- Thread starter jastutte
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
jastutte
Full Access Member
- Joined
- Dec 6, 2008
- Posts
- 129
- Reaction score
- 28
thanks again for all the info and advice, everyone.
mike, i pulled the idle control and it was very dirty. cleaned it and the tach needle seems a little tighter. idles very nice now.
02 sensors will have to wait for a while till i get some cash saved.
has any one spliced a trailer wiring harness into a D1?
mike, i pulled the idle control and it was very dirty. cleaned it and the tach needle seems a little tighter. idles very nice now.
02 sensors will have to wait for a while till i get some cash saved.
has any one spliced a trailer wiring harness into a D1?
