Lamp Assembly Rear High

[sonico]

Does anybody know how to replace the Lamp Assembly Rear High on LR3?

I can't find what is keeping it in place. The replacement part has no screw holes, or clips. It looks like a snap on.

Please help

 

[drzjoint]

INSIDE YOU WILL SEE A FEW (TORXS or philips can't remember) drop the hatch and liftgate, in the side of the assembly then pop it off. This is for the side blinker brake lights. Not sure on the 3rd brake light.
It is shown in the manual for the sides and probably the 3rd

 

[sonico]

Here's a picture of the Lamp that I'm trying to replace

The manual only shows how to remove the back sides break lights, but not the High Tailgate break light

 

[drzjoint]

Ya not sure on the 3rd brake light

 

[sonico]

It looks like the part is glued... I am just trying to avoid the dealers charge for replacing it.

 

[drzjoint]

It looks like the part is glued... I am just trying to avoid the dealers charge for replacing it.

be careful your rear washer spritzer is in there

 

[phurley]

Yep, the high-mount stop lamp is glued in place. If you're set on DIY, PM me your email and I'll get you the replacement procedure.

 

[Houm_WA]

How in the heck did THAT fail? Those are LEDs so it's not as if a light bulb burnt out.