CEL: Barometric Pressure Sensor

[scott schmerge]

I'm going to use this thread as impetus and get off my ass and call my local race/fab shop and see if they think they might be able to replicate the crossover pipe via custom welding or making one out of woven stainless.

I'm less concerned about cost, than eliminating a likely failure point that can toast your block without much, if any warning, in the middle of nowhere.

If anyone is interested, I will report back.

Interested. I also committed a while ago to see about 3D printing a crossover pipe with markforged. I too will look into it.

Question is, who wants to try the first part and risk toasting their engine?

 

[avslash]

Just posted a new thread, as well.

Does anyone have a failed crossover pipe they would donate as a template for a fab shop?

Shoot me a PM.