Disclaimer: Links on this page pointing
to Amazon, eBay and other sites may include affiliate code. If you click them and
make a purchase, we may earn a small commission.
If it’s plastic which I think it is you can heat up a straight screwdriver blade and push it in carefully as it will want to melt straight through and then screw it out. I’ve done this on a broken plastic sensor in a metal hot tub heater with great success.
Common. Just grab with some pliers and try to back it out. If it won't back out then drill it. I drilled mine with a twist bit and most plastic came out. I used a brass replacement. The remaining bits came out when I bled system.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.